Quiksteel 16402 Aluminium Reinforced Epoxy Putty, 2 OZ

Product Information

To apply Hi-Temp Lab-metal with a paint brush, it must be thinned to paint consistency with Lab-solvent, then applied with light brush strokes; not worked over as with paint. Dipping the brush into Lab-solvent periodically will keep the bristles free and prevent clogging.

Permanent repair compound, it is ready-to-use right from the can. Developed for difficult repairs subject to excessive heat, even in high-temperature applications, you can make permanent, rustproof, metal repairs with Hi-Temp Lab Metal. If a spool of aluminum wire isn’t going to be used cover the spool with the plastic bag the wire shipped in or with another protective cover. TIG cut-lengths are best stored in their original box to protect against dirt and debris.Aluminium trihydroxide can be added to casting resins at an approximate maximum percentage of 200% by weight (e.g. 200g of filler powder to 100g of resin). Doing so will reduce shrinkage, improve thermal stability considerably and result in a heavier more substantial feel to cast products however the resin will become harder to pour and reproduction of fine surface details will be impaired as the filler content is increased. Remember that not all epoxies are good for painting. However, if you have applied one that allows for it, use a self-etching primer. This formula includes the chemicals that help micro-etch the surface you are going to paint. Is Gorilla epoxy good for aluminum? It is recommended that the powder is mixed thoroughly with Part 'A' of polyurethane casting resins (like our Fast Cast) before adding part B. Never count the weight of the filler powder in the mix ratio. Yes, marine epoxy is designed to adhere to aluminum. It forms a strong bond that can withstand extreme weather conditions and harsh environments. However, it’s important to make sure the surface of the aluminum is properly prepared for the epoxy application. Before applying, you should clean the aluminum with a solvent or degreaser, then lightly sand or chemically etch it. This will ensure the best possible adhesion between the epoxy and aluminum. Additionally, make sure you select an appropriate type of marine epoxy for your project – some are better suited for specific applications than others. With proper preparation and selection of epoxy, you can trust your repair job will last for years to come. What can you put on aluminum to keep it from corroding?

Use the 80-grit aluminum oxide paper to abrade the surface before applying the sealant. Mind that aluminum is nonporous so sandpaper may not always be useful. Ensure that the surface is solid, so you need to remove all the blistering, old coating, flaking, and chalking before the application. Do I need to prime the aluminum before painting? Thin with Lab Solvent to ease spreadability. Typically dries in 24 hours, heat cure at 425 degF for 1 hour before exposing to high temperatures. Great for filling surfaces before powder coating where 2 or more coats are required.When welding 6XXX series aluminum or 5XXX series aluminum containing less than 3 percent magnesium, it is possible to use either a 4043 or a 5356 filler metal to complete the job. The same holds true for higher shear strength applications; however, it typically takes three fillet passes with a 4043 product to equal the shear strength of one pass using a 5356 filler metal.
Proper storage and handling
Proper storage and handling of aluminum filler metals is essential to ensuring the highest quality welds. It is important to keep the filler metals in a clean, dry area that is of a similar ambient temperature as the weld cell. Moving them from a cold area to a warmer area could cause condensation to form on the surface of filler metals and lead to poor weld quality.